Inspectors in this position set up, adjust and operate magnetic particle and liquid dye penetrant processes to accept/reject aerospace parts, assemblies, and ground support by inspecting and interpreting magnetic indications or penetrant surface discontinuities revealed.Interpret standards governing
The Most Recommended Aviation Job Website Search Jobs. Get Hired.
JSfirm

51108-029; Inspector Mag Part & Pentrnt A

Boeing Company • 
Auburn, Washington, United States
Position Type: Permanent
Share
Job Description:
  • Inspectors in this position set up, adjust and operate magnetic particle and liquid dye penetrant processes to accept/reject aerospace parts, assemblies, and ground support by inspecting and interpreting magnetic indications or penetrant surface discontinuities revealed.
  • Interpret standards governing acceptance or rejection, make decisions relative to questionable flaws and coordinate with metallurgy, X-ray, etc., groups to obtain analysis of defects.
  • Compile reports relative to magnetic particle and/or penetrant inspection results and new procedures.
  • Receive work assignment from team leader, supervisor, priority list, Non-conformance Management System (NCM), Material Processor Requirements Facilitator (MPRF), ready to work area or use on-line information systems to establish job priorities.
  • Receive/obtain parts with appropriate paperwork/on-line instructions per required procedures Verify all paperwork/on-line instructions (e.g., manufacturing order, applicable drawings, specifications, nonconformance items, and any other necessary documents) are complete, accurate and current.
  • Obtain and/or set up the detail part for magnetic particle/penetrant inspection, as required.
  • Perform process control checks (e.g., bath concentration, light intensity, temperatures) on magnetic particle/penetrant chemicals, liquids, and equipment at required intervals (e.g., daily, weekly, monthly) to ensure they meet specifications, as required.
  • Develop and submit magnetic particle technique sheet to appropriate Boeing Level 3 Non-destructive specialist for approval, prior to first part inspection.
  • Move parts to magnetic particle/penetrant inspection equipment using appropriate material handling equipment, as required.
  • Apply magnetic field to part (e.g., circular, longitudinal), using stationary/portable equipment.
  • Flow florescent particle bath over part, inspect for defects (e.g., cracks, seams) under darkened conditions with a ultra violet (UV) black light, per drawing and specifications.
  • Apply penetrant to part (e.g., dip, spray, brush), process through system using manual method and/or computer menu (e.g., wash, dry, develop), inspect part under darkened conditions with (UV) black light for defects, per drawing and specifications.
  • Identify and document discrepancies.
  • Secure non-conforming items in the appropriate area in order to maintain control and traceability.
  • Perform inspection of rework per engineers disposition.
  • Interface with internal/external organizations (e.g., engineering, planning, suppliers, metallurgical laboratory, Material Review Board, Quality Assurance Investigation) to provide clarification and/or additional information.
  • Verify certifications of tools and equipment.
  • Handle and monitor the use and disposing of hazardous materials in approved manner.
  • Confined space work/access is required at times to support rework on the airplane.
  • Employees crawl through an opening 17.75" X 10.00" in order to get inside the fuel cell.
  • Contact team leader/supervisor/Boeing Level 3 when assistance is needed.
Job Requirements:
Salary Range: Neg-Neg
Relocation:
Travel:
Job Ident #: 00000154106
Share
Job and company information not to be copied, shared, scraped, or otherwise disseminated/distributed without explicit consent of JSfirm, LLC

JSfirm, LLC

Roanoke, TX

jobs@jsfirm.com

JSfirm LLC, Privacy Policy

All rights reserved. 2001-2019 JSfirm